02-02-2012 09:00 AM - edited 03-01-2019 05:32 PM
I just brought up a ipv6ip tunnel to Hurricane Electric to help me begin to learn about IPv6.
The only debug command I have found for this type of tunnel is debug tunnel. I have found several show commands that give some info but I was looking for some debug commands.
I have been looking for a while this morning on cisco.com and other places but havent found anything yet.
Would appreciate some pointers since I dont seem to be finding anything.
Ron
02-13-2012 04:20 PM
debug ipv6 packet, but watch out - that can make a ton of debug messages.
02-14-2012 12:17 AM
#debug tunnel
#show interface tunnel 0 accounting
Reagrds
syed
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide