default ipv6 route dissapears in pppoe client configuration
I have pretty simple IPv6 over PPPoE connection to ISP using SLAAC:
ipv6 address autoconfig default
Initially everything works fine, but after 30 minutes default route disappears from my routing table. Obviously, my ISP does not send periodic RAs and does not provide long enough lifetime in its first (solicited) RA.
How can I keep default route in my routing table while PPPoE is up? Is there any way to send RS periodically?
I do not want to add permanent static route, because PPPoE is not always active.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...