Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

IPv6 link local address.

        I have configured IPv6 for clients, i am able to get IPv6 address from configured DHCP server (Win 2012).

From client it is showing following link local address as a gateway, i have configured manual address for link local.

fe80::1%11

I need to configure tag (description) for the link local address. i.e. insted of %11 it should show %<description>.

Is this configuration is supported.

Following is the details of my network devices.

L2 switch         WS-C3750-48TS  (12.2(55)SE1)

L3 switch         WS-C4507R    (12.2(25)EWA14)

Need assistance for the same.

1 REPLY
Cisco Employee

IPv6 link local address.

"%11" is not a tag, it is a zone identifier.

Have a look at http://tools.ietf.org/html/rfc6874 for more information about it.

735
Views
5
Helpful
1
Replies