03-18-2014 03:28 AM - edited 03-01-2019 05:44 PM
Hello,
What is it mean "C" in return icmp message?
R2#ping 192.168.1.201 r 100
Type escape sequence to abort.
Sending 100, 100-byte ICMP Echos to 192.168.1.201, timeout is 2 seconds:
!.!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!!.!!!!!!!!!!!!!!!!!!
!!!!!!.!!!!!!!!!!!!!!!!!!!!!!!
Success rate is 96 percent (96/100), round-trip min/avg/max = 52/86/120 ms
R2#ping ipv6 2001:DB8:0:200::1 r 100
Type escape sequence to abort.
Sending 100, 100-byte ICMP Echos to 2001:DB8:0:200::1, timeout is 2 seconds:
!!!!!!!!!!!!!!!!!!!!!!!!!!!!C!!!!!!!!!!!!!!!!!!!!!!!!C!!!!!!!!!!!!!!!!
!!!!!!!!C!!!!!!!!!!!!!!!!!!!!!
Success rate is 97 percent (97/100), round-trip min/avg/max = 40/77/104 ms
R2#
Ping to the same router one ping with ipv4 and other ipv6, what is C stand for...cannot find anything about this...
Regards,
Solved! Go to Solution.
03-18-2014 05:16 AM
03-18-2014 05:16 AM
03-18-2014 06:13 AM
Hello,
Marcin thank you for your reponce unfortunalty this is out of support threfore TAC case can not be opened. I am running version:
Cisco IOS Software, 7200 Software (C7200-ADVENTERPRISEK9-M), Version 15.0(1)M10
Regards,
03-18-2014 07:08 AM
I've raised internal documentation bug against "C" being missing.
I don't think you will be able to see it but it's CSCun78997.
On your side you can try 15.1(4)M4+ and see what that changes.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: