Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

restricting ipv6 pim rp to a specific group only

Hi,

I want to restrict the IPv6 pim rp to a particular group. No other group should be serviced by this pim rp.

How to achieve this?

The topology is as below:

R1(f0/0) ----- (f0/0)R2(f0/1) ------(f0/1)R3(f0/0)-----------(f0/0)R4(f0/1)

I want to configure R1 as the ipv6 pim rp. it should service only group FF08::1234:4567. I have configured the global ipv6 add of R1 (f0/0) as the pim rp add on all routers.

I have configured R4 as the receiver of the group FF08::1234:4567.

2 REPLIES
Community Member

restricting ipv6 pim rp to a specific group only

Hi puneet24,

Configure the PIM RP address of your router R1 fa0/0 IPv6 address for the multicast group FF08::1234:4567 only:

ipv6 access-list mygroup

permit ipv6 any FF08::1234:4567

ipv6 pim rp-address mygroup

http://www.cisco.com/en/US/docs/ios-xml/ios/ipv6/command/ipv6-i4.html#GUID-67D6A2B9-259F-4335-92C4-2D45A1FAE67A

Cisco Employee

Re: restricting ipv6 pim rp to a specific group only

1052
Views
0
Helpful
2
Replies
CreatePlease to create content