Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Unable to select tunnel mode ipv6ip

Hi.

Please, can you explain why I am not able to select tunnel mode "ipv6ip" on my switch. I would like to configure tunnel from Hurricane tunnelbroker.net.


switch-cisco-lab-cor(config-if)#tunnel mode ?

  aurp    AURP TunnelTalk AppleTalk encapsulation

  cayman  Cayman TunnelTalk AppleTalk encapsulation

  dvmrp   DVMRP multicast tunnel

  eon     EON compatible CLNS tunnel

  gre     generic route encapsulation protocol

  ipip    IP over IP encapsulation

  iptalk  Apple IPTalk encapsulation

  ipv6    Generic packet tunneling in IPv6

  nos     IP over IP encapsulation (KA9Q/NOS compatible)

switch-cisco-lab-core#show running-config interface tunnel 0

Building configuration...

Current configuration : 203 bytes

!

interface Tunnel0

description Hurricane Electric IPv6 Tunnel

no ip address

shutdown

ipv6 address 2001:xxx:xxxx::2/48

ipv6 enable

tunnel source 172.16.1.1

tunnel destination xxx.xxx.xxx.xxx

end

Switch Ports Model              SW Version            SW Image                

------ ----- -----              ----------            ----------              

*    1 52    WS-C3560G-48TS     12.2(53)SE            C3560-IPSERVICESK9-M



1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Unable to select tunnel mode ipv6ip

Hi,

You need Advanced IP services feature set for IPv6 in IPv4 tunneling feature support.

HTH

Laurent.

4 REPLIES
Cisco Employee

Unable to select tunnel mode ipv6ip

Hi,

You need Advanced IP services feature set for IPv6 in IPv4 tunneling feature support.

HTH

Laurent.

New Member

Unable to select tunnel mode ipv6ip

Hi.

Does this mean that I need to update the image?

Cisco Employee

Unable to select tunnel mode ipv6ip

Correct as you are currently using IP Services feature set.

New Member

Unable to select tunnel mode ipv6ip

Hi Laurent.

Thank you!

1389
Views
0
Helpful
4
Replies
CreatePlease login to create content