Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Using IPv6 hosts in IPv6 ACL

Hello Cisco experts.

While working with Cisco router with IOS  12.4(25b) I noticed that

I can configure  "ipv6 host" that can contain multiple ipv6 addresses,

I would like to use it in ipv6 acl but it seems that I can't.

Is there syntax or IOS version that allow me to use "ipv6 host" in ipv6 acl?

thank you

Everyone's tags (3)
2 ACCEPTED SOLUTIONS

Accepted Solutions

Re: Using IPv6 hosts in IPv6 ACL

Yes you can. ;-)

In this link is the syntax described to use a host as source or destination in an acl:

http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-sec_trfltr_fw.html#wp1072522

regards,

Leo

Silver

Using IPv6 hosts in IPv6 ACL

Hello Josef,

Here is another configuration example

IPv6 Traffic Filtering Access List Configuration Example

Regards,

Sunil.

Regards, Sunil Khanna
2 REPLIES

Re: Using IPv6 hosts in IPv6 ACL

Yes you can. ;-)

In this link is the syntax described to use a host as source or destination in an acl:

http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-sec_trfltr_fw.html#wp1072522

regards,

Leo

Silver

Using IPv6 hosts in IPv6 ACL

Hello Josef,

Here is another configuration example

IPv6 Traffic Filtering Access List Configuration Example

Regards,

Sunil.

Regards, Sunil Khanna
836
Views
0
Helpful
2
Replies