03-27-2012 08:49 AM - edited 03-01-2019 05:33 PM
Hi ,
Am just start to implement ipv6 to my network i want to know how to assign ipv6 to clients ?
now am set ipv6 on the router gateway at interface LAN only and then am check on a workstation
it can get ipv6 already this solution is correct or not?
which the best solution for assign ip address to a clients same as function dhcp ?
thank you.
03-27-2012 03:53 PM
Among most common solutions you will have:
- IPv6 RA (for pure address configuration) + DHCPv6 (for additional information), read about "managed" flag in RA.
- SLAAC - not every vendor implements it.
03-27-2012 11:02 PM
I have more question
how to assign dns-server , gateway , etc...
03-28-2012 02:49 AM
Hi,
you can use stateless DHCPv6: http://www.cisco.com/en/US/docs/ios/ipv6/configuration/guide/ip6-dhcp.html#wp1080090
Regards.
Alain
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide