We have CUCM 8.6 installed in house and I have successfully connected iPhone and Droid phones, however I have been unable to get my iPad3 configured as an endpoint. I have the most recent Jabber for iPad installed on the iPad but when I go to CUCM to add the device iPad is not one of the options. I can add the iPad as an iPhone, but video is not an option.
Is there a device pack which I will need to add to CUCM? I was under the impression that device support for iPad3 was included in the 8.6 release.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: firstname.lastname@example.org Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...