Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

After Jabber start ; delay ; show user@domain instead of resolve LDAP Contacts

Hello Community, Jabber shows to EDI in Jabber Config.xml. Use SIP URI to resolve contacts is false. When I start Jabber I see in my Call List for long time the URI user@domain.com instead of Contacts resolve by LDAP. It takes near 30sec until I see the resolve name from LDAP Contacts.

Is there any setting in Jabber config xml to speed up resolve Name, use local cache from last start up... etc....

Any help are appreciate or may be you had this issue also.

Thanks Armin

HTH, please rate all useful posts and right answers.       

HTH, please rate all useful posts and right answers.
  • Jabber Clients
1 REPLY

After Jabber start ; delay ; show user@domain instead of resolve

Armin, can you attach a problem report (HELP>problem report) when you start up the client.  at provide an exact time frame.  This should not take 30 seconds as you indicate

cheers


=============================
Please remember to rate useful posts, by clicking on the stars below. 

=============================

============================= Please remember to rate useful posts, by clicking on the stars below. =============================
405
Views
0
Helpful
1
Replies