We have Anyconnect setup to automatically launch when we open the Jabber voice client on our iPhones. For the most part it works fine. The issue we're running into is with connecting to voicemail and to the directory. If we launch Jabber and let anyconnect launch automatically, it takes a minute for the directory to connect and about 8 to 10 minutes for voicemail to connect. If we establish the VPN first and then open Jabber, everything will connect instantly. Has anyone else had this issue or have any ideas.
If you are using IP addresses instead of FQDN, this could happen. Are the On Demand domain settings correct? If you're using a filter, make sure the CRL for the target server is accessible because that will cause a huge delay.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...