Can Jabber for Windows 9.7 automatically use windows credentials?
In a CUCM 9.1 with IM&P on-premise, can a Jabber for Windows 9.7 automatically use the credentials used to login the user PC on domain?
We know that there are the two check box to launch jabber at login and sing in at launch, but it is not fully automatically, the end user need to enter the credential first and enter again in case of a password change.
Is there a way to use install arguments or a parameter at bootstrap to get the windows credential to sign in the Jabber )on-premise, not on cloud)?
Thanks in advance
PD: The documentations point that the SSO will only be available for version 10.5 and we are looking for an alternative solution.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...