Yes I have the same issue, and when you go to the profile in Jabber and hover over the profile, you get a new menue with a black "i". When you click on the "i" then only the number pulls through from CUCM.
This is very weird, does not happen to all users. I have the newest Jabber version 11 installed.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.