Re: Cisco Jabber Mobile client getting Unregistered
thanks for your reply
it stays registered but when i make a call the call goes good but once i disconnect the call after that it goes to unregister state. also some time it shows on my phone that it is connected but on CUCM it shows Unregistered.
these are the values i configured. for the values i refered this document
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.