Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Conversation pane does not close after call.

Hi,

I have a VCS to CUCM connection and the calls between a VC unit and a Jabber for Windows works well including video.

The issue that I have is when the VC unit disconnects the call the JFW client conversation pane does not close, it remains open as an active call with the timer still counting. It does not prevent me from making another call to that extension the conversation panes stack up. When making calls between clients registered on the CUCM this pane closes automatically.

If I login with my CUPC client I only get voice but the conversation pane does close in this situation.

Thanks

Everyone's tags (1)
7 REPLIES
New Member

Conversation pane does not close after call.

Is the client in deskphone or softphone mode? Is the behavour the same in both modes?

Is it possible to obtain a wireshark trace to assist us in determining whether it is a client or server side issue?

Regards

Shane

Bronze

Re: Conversation pane does not close after call.

Hi Shane,

I have not tested deskphone mode yet but here is the trace for the softphone mode.

Heath

New Member

Re: Conversation pane does not close after call.

Can you please open a TAC case and attach a problem report please?

Regards

Shane

New Member

Conversation pane does not close after call.

Hi Heath,

Just wanted to see if you found the cause of the problem.  We are currently experiencing the same issue but only when we call two of our users.  Everything within UCM appears to be configured identically so i'm assuming it's an mis-config on the clients.

Kyle

Bronze

Re: Conversation pane does not close after call.

Hi Kyle,

When the call remains on the CUCM cluster it is all good for me. The issue is only experienced when we are calling a VC system attached to a neighboured VCS and when the VC unit ends the call the pane stays active.

You you have a simular setup?

Cisco Employee

Conversation pane does not close after call.

Hi Kyle,

Shane is on holidays for a while, I can see what I can do to help out. I think a prt would be a good start and our engineers can have a look at it and see why the conversation window is staying around.

If you can get us that Kyle we should be able to make progress.

Thanks,

Derek

New Member

Conversation pane does not close after call.

Will do!

Thanks Derek.

647
Views
0
Helpful
7
Replies
CreatePlease login to create content