Enable active call transfer between Cisco Jabber Voice and desk phone
I am having an issue with the desktop integration with Jabber voice for iphone v9.1.6 IOS 7 ( CUCM 9.1.2 ) , in the admin guide I follow the Enable active call transfer between Cisco Jabber Voice and desk phone section with no success , I can make calls from the iphone to deskphone and vice versa but cannot control the deskphone from the iphone. I have setup as follows:
End user Mike associated with deskphone with allow control of device from CTI and CTI enabled
Deskphone ext 2000 with owner userid of Mike and allow control of device from CTI checked
Cisco dual mode device for iphone ext 2008 with owner userid of iphone and CTI control username of Mike
The next step stipulates navigate to the Directory number information page which I presume is ext 2000 to check Allow Control of device from CTI is ticked ( this option is not available for 2008 ) and the associated device box displays the deskphone and mobile device , however the associated device box only displays the deskphone - I am obviously doing something wrong , can someone point me in the right direction please..
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.