I have a CUCM and CUC 8.6 and I want to use an iPhone as an extension of a desk phone. I downloaded the Jabber application for the iPhone and I configured it on the CUCM. I selected the Option of Primary Phone for the desktop phone.
However, what I dont understand is that if I should put a DN on the iPhone phone in the CUCM. When i did it without a DN, it didnt register after i followed the setup wizard. when i put the same DN as the Desktop phone it does register.
It works fine that way ecept that when I call to the DN of the desktop and iPhone, the both ring at the same time, the problem comes when I pick up the Desktop and on the iPhone I get a message of "If you want to use this phone instead" and when I click yes, on the desktop phone (9971) there's a Call Park error that doesnt allow me to transfer the call to the iPhone.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.