I am having complete failure when trying to get any version of Jabber in 9.2, 9.6, or 9.7 to pass custom install values whether with a MST'd MSI or via a command line argumemt in a batchfile. It's beyond maddening, as I'm folowing the guides to the letter. As a task, this isn't difficult. And from the installer log, you can see it's passing the parameters. I did notice that it didn't build a bootstrap file though.
I've used both Orca and Insted with the same results. A Google search showed I wassn't the only one.
You have reached the Cisco Logistics Support Center.. To Check Status of
your RMA, visit Product Returns & Replacements (RMA). Need help? Contact
us by Phone or Email. North Americas Phone: 1800 553 2447 Option 4
Email: email@example.com Europe Phone: +3...
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...