Cisco supports in J4W to create your own MS-Installer File to deploy an application with all my personal settings (TFTP_FILE_NAME, Mode, ServerIP,....). That's realy nice and very handy.
Is it possible to open J4M App, to define my settings there and deploy. Or is there a way to create a *.pkg file with a simple script to define the settings after the installation. I'm testing some settings in the com.cisco.Jabber.plist but without any help is it a very long process. And my plan is to deploy a *.pkg file with the Cisco Jabber.app and my own *.plist file. Is this a way or is there a simpler one?
"If users have Cisco Jabber for Mac devices only, use the following command line argument to specify unique names configuration files for different groups:"
- How does the whole command look like in the terminal?
># ciscojabber.app TFTP_FILE_NAME=my-config.xml
- So the App has always to start over the terminal?
I have confirmed with our developers that this is currently not supported, we are working on a documentation defect to remove the line from the administration guide. Currently, the only way to use custom configuration files would be via the Cisco Support Field of the CSF device.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...