J4W 9.6.1 in phone-only mode not accepting URI dialing :(
I can successfully call CIPC from my J4W using directory numbers but when I enter directory uri into J4W it is not accepting it (I'm hitting enter but nothing happens). BTW, I added <EnableSIPURIDialing>true</EnableSIPURIDialing> into jabber-config.xml file, defined Organization Top Level Domain in Enterprise Parameters and applied directory uri for a CIPC line (together with the DN).
Can anybody confirm that described scenario is valid and working? Thanks!
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...