I have J4W version 9.6 with CUCM 9.1 integrated over SIP Trunk to VCS version 7.2 and EX90 endpoint. Whenever J4W make a call to EX90 the EX90 would answer the call but from J4W it is still ringing continously until hang up call (no audio or video). When EX90 make a call to J4W, the call is answered from J4W but from EX90 it is still ringing and then after 10 seconds a busy tone is heard on J4W.
If we enable MTP on the SIP Trunk the call is connected but I am getting no video because it is software MTP. However on the documentation I should not need to enable MTP. I have followed the documentation very carefully.
If we enable SIP trace for non-MTP call we see that the VCS just continously send INVITE but getting no respond back from CUCM. Am I hitting a bug?
I have the same problem - J4W version 9.6 registered with CUCM 9.1 trying to call EX90 registered with VCS 7.2.2 over a SIP trunk. Call is established but no audio/video. Checked Firewall and routing - no issues. Please let me know if you find something and I will do the same.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...