08-07-2013 11:50 AM - edited 03-17-2019 03:27 PM
Is it possible to assign a line 2 DN to Jabber in Cisco Call Manager?
Or is jabber (softphone mode) only a single line device ?
Thanks,
Keith
Solved! Go to Solution.
08-08-2013 03:09 AM
Single DN only I'm afraid. Multi-line is on the roadmap but I can't speak to a timeline.
Please remember to rate helpful responses and identify helpful or correct answers.
08-08-2013 03:09 AM
Single DN only I'm afraid. Multi-line is on the roadmap but I can't speak to a timeline.
Please remember to rate helpful responses and identify helpful or correct answers.
08-08-2013 05:52 AM
Thank you sir.
If you could exert your considerable influence and make this happen sooner than later that would rock.
Keith
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: