Jabber Client for Windows. Desk phone control trouble.
I have CUCM - version 184.108.40.20600-5, JFW version 9.2.3 build 4417 and Microsoft AD server.
I have configured:
1. LDAP directory in CUCM using SSL connection
2. LDAP authentication in CUCM using SSL connection (port 636) too.
All other configurations, needed for allowing CTI control from JFW to desk phone, are made.
So, the problem is: CTI control in JFW is not available in this case. But, if I change in CUCM LDAP authentication from SSL to non-SSL - all work fine. JFW establishs CTI connection and successfully controls my desk phone, when LDAP authentication does is non-SSL.
The short answer is that you don't.... That isn't entirely true while at
the same time it kind of is, but for the most part you don't configure
the softkeys. You enable or disable them via TCL. Here is the long
answer. Be sure to read the whole thing or e...
Topology: IP Phone > Switches > Microsoft NPS setup to forward 802.1x
proxy to > ISE 2.1 patch 3 Authentication: EAP-TLS using Cisco MIC SANs
Phone Models 802.1X support? 802.1x flavor Addtl Comment EAP-MD5 EAP-TLS
Cisco 3905 Y Y N Cisco 6911 Y Y N Cisco ...
This document describe how DST changes and how time changes are
implemented in DST. Daylight Saving Time (DST) is the practice of
setting the clocks forward 1 hour from standard time during the summer
months, and back again in the fall, in order to make b...