I recently started using Jabber on a double screen setup. After installing it, it docked as a drop down at the top of my #1 screen - I use Windows 7 - 64b. I discovered I could move the drop down tab to center, left or right, but only on my prime screen. That is a problem, because I use MS Office and Autodesk Revit, both of which use the (in)famous Microsoft ribbon. The Jabber dropdown overlaps the ribbon and dozens of times a day, especially in Revit, I get Jabber when what I wanted was from the Revit ribbon. Is there a way to move the docked Jabber dropdown to my #2 screen?
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.