Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Jabber for iPhone won't reconnect

Hello,

I have a customer that is facing an issue with Jabber for iPhone:

Jabber for iPhone will register correctly a first time but if user disconnects from wireless network, jabber may not reconnect back again. It will get into a loop where we can only see the attempt to reconnect. Closing the app doesn't seem to help.

IPhone is connected to WiFi when trying to reconnect to CUCM and wifi is working.

Sometimes Jabber will reconnect, sometimes it won't unless we do a reset of the device (TCT) directly on CUCM.

Has anyone experienced this?


Sent from Cisco Technical Support iPhone App

1 REPLY
New Member

Jabber for iPhone won't reconnect

I'm not sure if this would be the issue but, there are two SSIDs users connect to.

Both of the SSIDs allow Jabber to contact CUCM IP address but issue will occur most likely when users change from one SSID to the other.

Would the IP change be the root cause of the issue? Is there any configuration we can add to CUCM so Jabber tries to reconnect no matter what?

251
Views
0
Helpful
1
Replies
CreatePlease login to create content