Jabber for windows In a meeting status not correct upon opening.
Not sure if anyone else has experienced this, but if you have meeting in calendar at 8am- 8.30am, and you open Jabber for Windows at say 8.15am, upon initial opening the client will show as Available, even though In a meeting. If you go off-hook the status will then change to In a Meeting but revert back to Available once back on-hook. Once 8.30am comes around and the Available becomes correct all following appointments work.
My question is has anyone struck this before? Is this a known fault that when opening Jabber across a meting the status does not appear on your client.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.