I have a client which would want to route all Jabber traffic (signalling and RTP) thru the internet even for user which are on the internal network, their justification for this is voice and video traffic over the internet is cheap compare to their MPLS cost.
Can i use, the Expressway MRA to do this.
I'll have to configure the internal DNS SRV to have collab-edge and remove cisco-uds and cuplogin. Then even internal network Jabber users would reach the Expressway for registration.
Are you getting this error “Installer User Interface Mode Not Supported. The installer cannot run in this UI mode. To specify the interface mode, use the -i command-line option, followed by the UI mode identifier. The value UI mode identifiers...
The below trick might come handy when you have to add a new node to a cluster but you don't have or is unsure of the security password for the publisher. This procedure has been around for ages.
1) Login into the CLI of the Publisher.