Re: How can I dial in with Cisco Jabber into a scheduled TP sess
Thanks a lot for your feedback with regards to my question. I had opened a case with GTRC in parallel (attached) and have been asked to request for the jabber service through service catalog first to be eligible for dialing in with Cisco Jabber Video into an internal TP session.
However, after that it’s still not clear for me how to dial in with Cisco Jabber into a TP session now, respectively how it needs to be scheduled.
Is there any quick guide explaining step by step how its working? That would be very helpful to let this great App fly J
Thanks again in advance for your support. I look forward to hearing from you again soon.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...