Has anyone come across the above yet. the ipad is signed in and connected to my company wi-fi, i have even created a subzone on my VCSc just for testing with the IP address of the ipad but all i keep getting is the above. Am i missing an option key off my VCS to enable this? or is there something else, any help would be appreciate
I am having the same issue, I even try and send problem report, but it pop's up so fast, you can't even see it. I was able to take a screen shot, showing the email but the TO and Cc/Bcc lines are blank, and the subject line is there but the email is otherwise blank. I am able to connect using the Xvio-HD app on my ipad with only 1 issue. It shows all my contacts as off line.
Hi every one!!!When you are configuring a remote VPN connection, there
are some steps that are lost on the path. Here you can see those steps.
A) In your Cisco device: 1. Ensure you don´t have any rule denying the
traffic between the device and the remote...
Introduction: This document describes how to connect SG300 with Catalyst
switch via STP. Spanning Tree Protocol (STP) is a Layer 2 protocol that
runs on mainly on switches. The specification for STP is IEEE 802.1D.
The main purpose of STP is to ensure tha...
You have a Cisco Unified Communications Manager (CUCM) system and want
to configure a SPA112 analog telephone adaptor (ATA) to register to the
CUCM so that you can use up to two analog phones or similar FXS devices
with the CUCM.In this application note, ...