1 Pair "2 wire" T1 connection to Cisco 2600 Router
My internet provider can not run a T1 extension for my company into our office so I am attempting this myself. This provider uses a 1 pair "2 wire" T1 connection which I have not seen before. What is the proper way to connect from the T1 provider located 100ft away in the telco closet into the Cisco 2600 router? I need to build the cable and install a biscuit jack with jumper on each end but I am unsure what 5 pair configuration to use so that I can feed into the 2600 properly.
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...