Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

10/100/1000 Modules compatiblity with CatOS / IOS

Hi,

Can someone be able to advise me if the same 10/100/1000 48 port module (WS-X6148A-GE-45AF) can be used in two 6509 switches - one switch with SUP1A-2GE supervisor eninge running CatOS and other one with SUP32 supervisor engine running Cisco IOS.

All the cisco documents that I went thru do not differentiate between the two Operating systems for the ethernet modules.

thanks,

Ali

1 ACCEPTED SOLUTION

Accepted Solutions
New Member

Re: 10/100/1000 Modules compatiblity with CatOS / IOS

You must have cat OS 8.4 See below.

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_bulletin0900aecd801e621e.html

You must have 12.2 IOS.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_white_paper0900aecd80233a77.shtml

The other thing you need to look at is the power requirements and make sure you have the power supplies capable of providing the power needed.

HTH

Robert

1 REPLY
New Member

Re: 10/100/1000 Modules compatiblity with CatOS / IOS

You must have cat OS 8.4 See below.

http://www.cisco.com/en/US/products/hw/switches/ps708/prod_bulletin0900aecd801e621e.html

You must have 12.2 IOS.

http://www.cisco.com/en/US/products/hw/switches/ps708/products_white_paper0900aecd80233a77.shtml

The other thing you need to look at is the power requirements and make sure you have the power supplies capable of providing the power needed.

HTH

Robert

125
Views
0
Helpful
1
Replies
CreatePlease to create content