Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

10 G connectivity between X2 & SFP

Hi,

I want to connect WS-C2960S-48TD-L switch to WS-X6708-10G-3CXL module in Cisco WS-C6503-E switch. WS-X6708-10G-3CXL is C6K 8 port 10 Gigabit Ethernet module with DFC3CXL which requires X2 module. on the otherhand, WS-C2960S-48TD-L requires SFP+. Now is it possible to interconnect these two switch interfaces if I use LIU in between. or does WS-X6708-10G-3CXL module supports CVR-X2-SFP+ to use SFP+ transceivers.

Regards,

Sagar

Everyone's tags (7)
1 ACCEPTED SOLUTION

Accepted Solutions
VIP Super Bronze

10 G connectivity between X2 & SFP

Hi,

Sure, you can connect them together.

The 6500 side is SC type connector and the 2960 side is LC type connector. So, all you need is a fiber patch cord with one side LC (2960) and one side SC (6500).

HTH

2 REPLIES
VIP Super Bronze

10 G connectivity between X2 & SFP

Hi,

Sure, you can connect them together.

The 6500 side is SC type connector and the 2960 side is LC type connector. So, all you need is a fiber patch cord with one side LC (2960) and one side SC (6500).

HTH

VIP Super Bronze

10 G connectivity between X2 & SFP

BTW, if your optics are Single Mode (SM) you need SM patch cord.  If they are you Multi-mode (MM) you need MM fiber.  The fiber patch cord has to match the optics.

HTH

443
Views
0
Helpful
2
Replies
CreatePlease to create content