- Conversation started today
8:55pmRohit SauravHi ,
My Egress router 2951 is experiencing 100% high cpu utilization periodically , leading loss of session .can't able to ping the devices and lot more. The RX and TX load is completly utililzed.
Please give your suggestion soon.
IOS image is: c2951-universalk9-mz.SPA.151-4.M4.bin.
and some outputs: GigabitEthernet0/2 is up, line protocol is up Hardware is PQ3_TSEC, address is acf2.c56d.90e2 (bia acf2.c56d.90e2) Description: ## GL LAN ## Internet address is 121.241.126.81/28 MTU 1500 bytes, BW 10000 Kbit/sec, DLY 100 usec, reliability 243/255, txload 255/255, rxload 255/255 Encapsulation ARPA, loopback not set Keepalive set (10 sec) Full Duplex, 100Mbps, media type is RJ45 output flow-control is unsupported, input flow-control is unsupported ARP type: ARPA, ARP Timeout 02:00:00 Last input 00:00:00, output 00:00:00, output hang never Last clearing of "show interface" counters never Input queue: 3/75/106/0 (size/max/drops/flushes); Total output drops: 9671865 Queueing strategy: fifo Output queue: 0/40 (size/max) 30 second input rate 17622000 bits/sec, 14770 packets/sec 30 second output rate 50965000 bits/sec, 7172 packets/sec 37029519051 packets input, 12104220500074 bytes, 0 no buffer Received 3597691 broadcasts (0 IP multicasts) 0 runts, 0 giants, 12 throttles 241694636 input errors, 0 CRC, 0 frame, 241694636 overrun, 0 ignored 0 watchdog, 587291 multicast, 0 pause input 32625713765 packets output, 26488083991281 bytes, 0 underruns 0 output errors, 0 collisions, 1 interface resets 322562 unknown protocol drops 0 babbles, 0 late collision, 0 deferred 1 lost carrier, 0 no carrier, 0 pause output 0 output buffer failures, 0 output buffers swapped out GigabitEthernet0/2.1 is up, line protocol is up Hardware is PQ3_TSEC, address is acf2.c56d.90e2 (bia acf2.c56d.90e2) Description: ## GL LAN ## MTU 1500 bytes, BW 100000 Kbit/sec, DLY 100 usec, reliability 243/255, txload 255/255, rxload 255/255 Encapsulation ARPA ARP type: ARPA, ARP Timeout 02:00:00 Keepalive set (10 sec)
