100BaseFX-FE SFP Full Duplex in 3560-POE-8 Switch?
Is there a way to set a 100FX-FE SFP module installed in a 3560-POE-8 Switch to operate in full duplex mode. It is autonegotiating to half duplex and will not accept the "duplex full" command under the GigabitEthernet0/1 interface configuration.
Re: 100BaseFX-FE SFP Full Duplex in 3560-POE-8 Switch?
Thanks for the advice. Once I applied the media-type sfp command I was able to apply the duplex full command to the interface. Before then the fiber link would only link in at half duplex. Thanks for the help.
We are pleased to announce availability of Beta software for 16.6.3.
16.6.3 will be the second rebuild on the 16.6 release train targeted
towards Catalyst 9500/9400/9300/3850/3650 switching platforms. We are
looking for early feedback from customers befor...
Introduction Featured Speakers Luis Espejel is the Telecommunications
Manager of IENova, an Oil & Gas company. Currently he works with Cisco
IOS® and Cisco IOS XE platforms, and NX to some extent. He has also
worked as a Senior Engineer with the Routing P...
In this session you can learn more about Layer 3 multicast and the best
practices to identify possible threats and take security measures. It
provides an overview of basic multicast, the best security practices for
use of this technology, and recommendati...