I have a 1751 router with a WIC-4ESW 4-port switch module in slot 0 and a WIC-1ADSL interface module in Slot 1; when I boot the router, it gives this error:
"Smart Init is disabled. IOMEM set to: 20
Unknown Card in slot 0
%C1700-3-TDMMODIFUNKNOWN: TDM Module does not support WAN Interface module 64 in slot 1"
I upgraded to IOS 12.3(23) with no change in symptoms.
When I perform a 'show running-config', the only interface that appears in the output is FastEthernet 0/0, which is built into the chassis; no other interfaces show.
I've attached a file that shows the boot output, 'sh running-config' and 'sh version' output; the router is otherwise at factory default configuration, save for the F0/0 interface, which is configured to reach my workstation TFTP server.
Explanation The WAN interface card was not recognized by the TDM module. Internal connections required for this WAN interface card to function were not made.
Recommended Action Copy the error message exactly as it appears on the console or in the system log, contact your Cisco technical support representative, and provide the representative with the gathered information.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...