Hello, I'm having trouble setting up a router to allow access to the internet. I'm sure it's something simple but I can't seem to figure it out and was hoping someone could help?
The setup is cable modem/router connected to fa1 giving it the ip address 192.168.0.15 then computers connected to a couple of ports (fa2-5) getting dhcp addresses from the router.
what's happening is:
can ping internet from router (fa1 to google.com - OK)
can ping fa1 from vlan 1 interface ( vlan 1 to fa1 - OK )
can't ping internet from vlan 1 interface ( vlan 1 to google.com - no response )
(computers can ping each other).
If anyone has any recommendations I'd appreciate it.
Thanks,
config below:
router#show run
Building configuration...
Current configuration : 1547 bytes
!
version 12.4
service timestamps debug datetime msec
service timestamps log datetime msec
no service password-encryption
!
hostname router
!
boot-start-marker
boot-end-marker
!
no aaa new-model
!
resource policy
!
ip cef
no ip dhcp use vrf connected
ip dhcp excluded-address 192.168.2.1
!
ip dhcp pool mainpool
network 192.168.2.0 255.255.255.0
dns-server 192.168.0.1
default-router 192.168.2.1
!
interface FastEthernet0
no ip address
shutdown
duplex auto
speed auto
!
interface FastEthernet1
ip address dhcp
ip nat outside
ip virtual-reassembly
duplex auto
speed auto
!
interface FastEthernet2
!
interface FastEthernet3
!
interface FastEthernet4
!
interface FastEthernet5
!
interface FastEthernet6
!
interface FastEthernet7
!
interface FastEthernet8
!
interface FastEthernet9
!
interface Vlan1
ip address 192.168.2.1 255.255.255.0
ip nat inside
ip virtual-reassembly
!
interface Async1
no ip address
encapsulation slip
!
ip default-gateway 192.168.0.15
!
ip http server
no ip http secure-server
ip nat inside source list 1 interface FastEthernet1 overload
!
access-list 1 permit 192.168.2.0
!
control-plane
!
line con 0
line 1
modem InOut
stopbits 1
speed 115200
flowcontrol hardware
line aux 0
!
end
