1811 router w. bridging turned on, question about the MAC address table
I have an 1811 router with bridging turned on (needed for wireless to work) and a (non-Cisco) switch plugged into one of the ports. When I do a "show mac-address-table", I only see one MAC address per port... shouldn't I see a bunch of MAC addresses on the port that has the switch? The site is reporting intermittent connection problems to devices on the switch and I'm thinking it's because it doesn't know where to send the packet. Do I need to enable something to turn on multiple MAC addresses on a port?
I have done a "bridge mac-address-table limit 0" ("0" disables the limit), but I still don't see multiple MACs per port
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.