Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

1812 router... switch ports

Hi all,

A question with regards to the 1812, I was hoping to be able to set specific mac-addresses to be able to access ports as we had done with previous switches eg:

switchport mode access

switchport port-security

switchport port-security mac-address xxxx.xxxx.xxxx

However I find no such commands in the ios, I've tried 12.4(6)T8 advK9 and also adventerprise, I've also gone through SDM and nothing along those lines either. Can anyone confirm that allowing only a specific MAC to access a specific port is do able on the 1812 ? Or is it aimed at the NAT/DHCP/Firewall side of things.

Thanks,

Steve.

1 ACCEPTED SOLUTION

Accepted Solutions

Re: 1812 router... switch ports

Steve,

Only static port security is supported on the c18xx platforms.

The CLI is "mac-address-table secure"

Reference:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/swtc

h_r/swi_m1.htm#wp1085966

Regards,

~JG

Please rate helpful posts

2 REPLIES

Re: 1812 router... switch ports

Steve,

Only static port security is supported on the c18xx platforms.

The CLI is "mac-address-table secure"

Reference:

http://www.cisco.com/univercd/cc/td/doc/product/software/ios123/123cgcr/swtc

h_r/swi_m1.htm#wp1085966

Regards,

~JG

Please rate helpful posts

New Member

Re: 1812 router... switch ports

Hi JG,

Thanks for the reply, it took me a couple of goes to figure out that it doesn't drop the port once a secure mac is set in the table, it just doesn't talk if a different machine is connected! It has solved my problem so thanks again !

274
Views
0
Helpful
2
Replies
CreatePlease to create content