Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

1841 Config

I'm not sure if this is the right place to post, but I can't seen to find the answer after several hours of searching online.

I'm working with an 1841 router with 2 ethernet ports. What I want to do is to set them to foward packets back and forth. This has to be bi-directional, so a gateway of last resort will probably not be feasible.

Any suggestions or hints about how to configure this?

2 REPLIES

Re: 1841 Config

Hi

You need to have proper routing defined on the router so that the traffic can move to and fro.

regds

Re: 1841 Config

By default the router will route between the directly connected subnets, as it knows how to get to them both.

106
Views
0
Helpful
2
Replies
CreatePlease login to create content