You can certainly route between the FastEthernet ports of the 1841. Eash FastEthernet is an independent routed layer 3 interface. I have set this up a number of times and it works quite well. Just put an IP address and subnet mask on FastEthernet0/0 and another IP address and subnet mask on FastEthernet0/1. The 1841 automatically routes between these subnets. Of course you will need some source of routing information (static routes or dynamic routing protocol) for networks and subnets that are not locally connected.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...