I have an 1841 router connected to Verizon DIA for Internet. I can SSH to the router but I can not ping a device with a static IP address in the same block of IP's that Verizon gave me. Device I try to ping is 18.104.22.168. router config is below. I should not need any NAT statements??
the fa0/0 interface is 22.214.171.124, and from there a cable goes to a WAN port on a VPN device and that has the address of 126.96.36.199. from the fa0/0 interface I ping just fine to the internet, but if I swap out the VPN device and attach a laptop to the fa0/0 interface and statically assign 188.8.131.52 to the laptop, I can ping 184.108.40.206, but it will not get out to the Internet.
I am confused, it should go right out, no access lists or anything, just a very basic config on the router shown above. Verizon had me change to ip route 0.0.0.0 0.0.0.0 220.127.116.11 which is the Verizon side of the WAN block. Still no go.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.