I have a SUP8-E on a WS-C4507R+E chassis. According to documentation, the uplink ports does support 1G/10G SFPs. I plugged in 1G SFP but why does it still showing "TenGigabitethernet" when you "show run" or "show interface". Is there any special configuration that needs to be done?
If you check the sh interface output which can show you the settings of 1g limitations..... it will not reflect in configs.... since that interface is capable to handle 10G but you are limiting it to 1G.
It is something like setting a speed 100 in a 1 G capable interface..... :)
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...