Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

.1q tunnel and untag frame config issue

Hi,

I am facing a problem to integrate access connection (untaged frame) to my metro Ethernet network for different different customers. In my network

Customers have two type of connections some are trunk(l2 switch) and some are access(PC), How I can configure the access port with S-VLAN tag at my me 3400 switch where previously QinQ configuration to untouched customer vlan.

Please see the below scenario

Customer SW-2960_A(trunk)-------(.1q Tunnel)ME-3400------(Trunk)------ME-3400(.1q tunnel)-------------(trunk)_Customer SW-2960_B

( Vlan 2,3,4,5)                                                                                                                                       ( Vlan 2,3,4,5)

PC------------------------------------------------------------ME-3400--------(Trunk)-----ME-3400------------------------------(trunk)_Customer SW-2960_B

( Vlan untag, 2,3,4,5)                                                                                                                  ( Vlan untag replace to 6, 2,3,4,5)

I will be glad if you write for me..

Thanks,

Mamun

518
Views
0
Helpful
0
Replies
CreatePlease to create content