Re: 1st time configuring a 1700 router. Need help changing IP ad
I certainly agree with Jon that 22.214.171.124 goes on your serial interface. I think that perhaps we need to know a bit more about how the router is currently configured before we say what to do with the default route. If the default route is configured like ip route 0.0.0.0 0.0.0.0 a.b.c.d then I agree that you will need to change a.b.c.d to 126.96.36.199. But if the default route is configured like ip route 0.0.0.0 0.0.0.0 serial 0 then there is no need to change it.
We also need to know a bit more about how the router is configured to know what to do with the LAN IP block that they gave you. If the router is configured to do address translation using a block of addresses from the previous ISP (and I would guess that it is) then you will need to change the address pool to use the LAN IP block. Or your router might have the public addresses configured on the FastEthernet interface, in which case the LAN IP block goes on the FastEthernet interface.
I would also suggest that you check to see if there are access lists which reference addresses from the previous ISP and if there are then these access lists need to be updated.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.