Recently my company merged with another and now we've to think again about all our network.
For that we've bought two 4500-x with 16 10gbe ports. With those two switch I've made a VSS.
Our new network is actually made with two completely separated network (by chance, they don't use the same IPv4 private class, but they have each a VTP domain and their VLANs) and we're going to let them separated but for the IT operations we're going to connect them via VRF and contrel them with some ACLs.
Our VSS of 4500-x will be used to route the vlan of each network between them. How can I transmit the good vlan (via VTP), to the good network ?
Is there any way to configure 2 VTP server on my Switch ??
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...