Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

2 x vlans on a layer2 switch

Hello,

I have a Juniper server plugged into a Layer2 switch on vlan100 on my dmz and this works ok.  Now i want to plug in an internet mail server onto that layer2 switch but in vlan193.  However when i do a no shut on vlan193, vlan 100 goes into shutdown state.

Is their anyway of keeping both vlans working.  i have attched some of the layer2 switch code.

The address of the Alexander server is this

192.168.193.140

255.255.255.128

192.168.193.129

regards

Kevin

2 REPLIES

Re: 2 x vlans on a layer2 switch

Hello,

I have a Juniper server plugged into a Layer2 switch on vlan100 on my dmz and this works ok.  Now i want to plug in an internet mail server onto that layer2 switch but in vlan193.  However when i do a no shut on vlan193, vlan 100 goes into shutdown state.

Is their anyway of keeping both vlans working.  i have attched some of the layer2 switch code.

The address of the Alexander server is this

192.168.193.140

255.255.255.128

192.168.193.129

regards

Kevin

Hi Kevin,

Layer two switches can have only one SVI interface basically used for management purpose,I would suggest you can have layer 3 switch or router for intervlan routing between the vlans.

Check out the below link for inter vlan routing configuration

http://www.cisco.biz/en/US/tech/tk389/tk815/technologies_configuration_example09186a008015f17a.shtml

Hope to Help !!

Ganesh.H

Remember to rate the helpful post

Hall of Fame Super Gold

Re: 2 x vlans on a layer2 switch

Configure the port as a dot1Q trunk and allow the VLANs of your choice.

196
Views
0
Helpful
2
Replies