cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
905
Views
0
Helpful
5
Replies

20gbit Port-channels using sfp+ ports

Kieran Panesar
Level 1
Level 1

Hi,

I am hoping to implement a cost affective solution that can utilise the uplinks ports on the 2960-X & XR series switch and the appropriate up/downlink modules for the 3750-X series switch

Would anyone know if it is possible to bundle the 10gbit sfp+ ports into a 20gbit port-channel?

Has anyone done this or could they point me in the right direction for documentation?

Thanks

1 Accepted Solution

Accepted Solutions

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

Yes, you can bundle multiple 10Gig ports on all these devices as long as you have the proper modules.  The 2960-X supports up to 24 Etherchannels and the XR supports up to 48.

If you are uplnking the 2960 series to 3750-X, you need a 10Gig module for the 3750-X series.

HTH

View solution in original post

5 Replies 5

Reza Sharifi
Hall of Fame
Hall of Fame

Hi,

Yes, you can bundle multiple 10Gig ports on all these devices as long as you have the proper modules.  The 2960-X supports up to 24 Etherchannels and the XR supports up to 48.

If you are uplnking the 2960 series to 3750-X, you need a 10Gig module for the 3750-X series.

HTH

devils_advocate
Level 7
Level 7

Assuming your 2960x series has SFP+ ports then you should be able to do that.

You would need a C3KX-NM-10G for the 3750x.

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

BTW, don't forget, you only have two 10g ports per 3750X.

Kieran Panesar
Level 1
Level 1

Thanks for clarifying that everyone

I am looking to aggregate x4 20gbit port-channels (8 links) into x4 3750-x with the appropriate modules

Thanks again

I am looking to aggregate x4 20gbit port-channels (8 links) into x4 3750-x with the appropriate modules

Sure you can.  Whether or not your switch can fully push 20 Gbps is another question. 

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card