Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

wuh
New Member

2501 stuck in cold start

Hi, all.

I have a 2501 router. Everytime, when it starts, it stops, saying snmp agent on host router is undergoing a cold start...

even when it wouldnt stop when i type break to go Rommon mode.

what might be the problem. I've copied the message here.

===========

00:00:09: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state

to up

00:00:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta

te to down

00:00:20: %SYS-5-CONFIG_I: Configured from memory by console

00:00:23: %LINK-5-CHANGED: Interface Serial0, changed state to administratively

down

00:00:23: %LINK-5-CHANGED: Interface Serial1, changed state to administratively

down

00:00:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state

to down

00:00:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state

to down

00:01:04: %SYS-5-RESTART: System restarted --

Cisco Internetwork Operating System Software

IOS (tm) 2500 Software (C2500-IO-L), Version 12.2(26), RELEASE SOFTWARE (fc2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Sat 31-Jul-04 03:32 by eaarmas

00:01:04: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing a cold star

tˇ

System Bootstrap, Version 11.0(10c), SOFTWARE

Copyright (c) 1986-1996 by cisco Systems

2500 processor with 16384 Kbytes of main memory

F3: 9286440+846656+770252 at 0x3000060

Restricted Rights Legend

Use, duplication, or disclosure by the Government is

subject to restrictions as set forth in subparagraph

(c) of the Commercial Computer Software - Restricted

Rights clause at FAR sec. 52.227-19 and subparagraph

(c) (1) (ii) of the Rights in Technical Data and Computer

Software clause at DFARS sec. 252.227-7013.

cisco Systems, Inc.

170 West Tasman Drive

San Jose, California 95134-1706

Cisco Internetwork Operating System Software

IOS (tm) 2500 Software (C2500-IO-L), Version 12.2(26), RELEASE SOFTWARE (fc2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Sat 31-Jul-04 03:32 by eaarmas

Image text-base: 0x03050A44, data-base: 0x00001000

cisco 2500 (68030) processor (revision A) with 16384K/2048K bytes of memory.

Processor board ID 01207578, with hardware revision 00000000

Bridging software.

X.25 software, Version 3.0.0.

1 Ethernet/IEEE 802.3 interface(s)

2 Serial network interface(s)

32K bytes of non-volatile configuration memory.

16384K bytes of processor board System flash (Read ONLY)

Press RETURN to get started!

00:00:07: %LINK-3-UPDOWN: Interface Ethernet0, changed state to up

00:00:08: %LINK-3-UPDOWN: Interface Serial0, changed state to up

00:00:08: %LINK-3-UPDOWN: Interface Serial1, changed state to down

00:00:09: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state

to up

00:00:18: %LINEPROTO-5-UPDOWN: Line protocol on Interface Ethernet0, changed sta

te to down

00:00:20: %SYS-5-CONFIG_I: Configured from memory by console

00:00:21: %LINK-5-CHANGED: Interface Serial0, changed state to administratively

down

00:00:23: %LINK-5-CHANGED: Interface Serial1, changed state to administratively

down

00:00:23: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial0, changed state

to down

00:00:26: %LINEPROTO-5-UPDOWN: Line protocol on Interface Serial1, changed state

to down

00:01:04: %SYS-5-RESTART: System restarted --

Cisco Internetwork Operating System Software

IOS (tm) 2500 Software (C2500-IO-L), Version 12.2(26), RELEASE SOFTWARE (fc2)

Copyright (c) 1986-2004 by cisco Systems, Inc.

Compiled Sat 31-Jul-04 03:32 by eaarmas

00:01:04: %SNMP-5-COLDSTART: SNMP agent on host Router is undergoing a cold star

tˇ

+++++++++++STOPS HERE, then i reboot it.

3 REPLIES
Purple

Re: 2501 stuck in cold start

Are you saying that it starts rebooting over and over by itself ? Otherwise that is a normal end of boot message meaning it is ready to configure , just hit the enter key at that point.

wuh
New Member

Re: 2501 stuck in cold start

No, it is rebooting over and over. it just freezes there. then after I reboot, it does the same thing.

wuh
New Member

Re: 2501 stuck in cold start

Sorry, a typo. Please ignore the last message i added. it should be.

No, it is NOT rebooting over and over. it just freezes there. then after I reboot, it does the same thing.

thanks,

576
Views
0
Helpful
3
Replies