Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

2600 not recognizing nm-1e network module

I have just installed - Cisco NM-1E-2W Dual-WIC Network Module w Ethernet - in a 2600 but it is not recognized. When I do show-ip-interface-brief, all interfaces are listed but not e0.

Do I have to install a driver too?

2 REPLIES
Green

Re: 2600 not recognizing nm-1e network module

You may need to update the IOS and / or that NetMod may not be compatible with your chassis.

Post up some details (like a SHOW VER) and or take a look at the "Compatibility Matrix" on Cisco's main site (under Support / Tools)

Good Luck

Scott

New Member

Re: 2600 not recognizing nm-1e network module

Z,

The NM1E-2W is not compatible with the 26xx series routers.

HTH,

lP

227
Views
0
Helpful
2
Replies
CreatePlease login to create content