I need to create configurations for some 2811s to replace some 26xx devices. When I create the configs I will not have access to the 2811s; someone else will be configuring the 2811s based upon my completed configs.
I am hoping you can point me to a reference and/or let me know what configuration differences exist between 26xx devices and 2811s. I don't believe there are many. The only of which I am aware are differences in the modules.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...